Macro Mode - Marantz SR7300 User Manual

Erasing the all functions
1.
Press and hold down the T.MODE and MEMO buttons until
LEARN is displayed in the display.
2.
Press and hold down the CL button and press POWER ON and
POWER OFF button.
• A-CLR and LEARN are blinking.
3.
Press OK button to continue erasing.
• A-CLR is displayed for 3 seconds and the mode returns to
LEARN mode.
• To cancel the erasing operation, do not press OK button and
simply touch any other button.
4.
To return the USE mode, press and hold down the OK button
until USE is displayed in the display.
Note:
• Erasing codes will return to the factory preset code, or there will
leave empty if the button has no factory preset code.
42

MACRO MODE

PROGRAMMING MACROS
Macros make it possible to use a single function button to perform
more complex series of operations that would normally require
pressing several buttons. A single button can be programmed to
perform up to 10 steps in sequence. A typical example of such a series
might be as follows:
• Turn the main amplifier power ON → Switch the function to DVD →
Set the Surround Mode to Virtual → Set the DVD player to PLAY.
• No signals may be transmitted during macro programming.
• The various steps that make up a macro are set initially to be sent
one after another in 1 second intervals, however these intervals
may be shortened to as little as 0.5 seconds or lengthened to as
much as 5 seconds using the Setup mode.
• In the macro mode, the number of steps the macro is displayed the
following selected function name.
• Macros may be programmed for each of the 12 function buttons as
follows;
TV, DVD, VCR1, DSS, TUNER, CD, CDR, MD, TAPE, AUX1,
AUX2, AMP
1.
Press and hold the T.MODE and MENU button until the MACRO
is displayed.
• MACRO and LEARN indicators are displayed blinking on the
LCD, too.
2.
Press the Function button for which you wish to program a series
of operations.
In this case, let's use the example of the DVD player.
Press the DVD Function button. The LCD will display DVD-M.
Characters displayed on LCD include the following, depending on
the function button for which the macro is being programmed:
TV-M, DVD-M, VCR-M, DSS-M, TUN-M, CD-M, CDR-M, MD-M,
TAP-M, AX1-M, AX2-M, AMP-M
• If a macro has already been set for the selected function
button, the LCD will blink.
3.
Press the buttons for the operations you wish to program as a
macro in the sequence you want the macro to program them.
For example, press DVD, PLAY.
• The number of steps in the macro is displayed on LCD and
this number increases by 1 with each button pressed.
• Each function button can be programmed to perform up to 10
steps in sequence.