Front Hub Bearing Removal
Remove the front wheel (see Front Wheel Removal), and
take out the following.
Grease Seals [B]
Use the bearing remover to remove the hub bearings [A].
Do not lay the wheel on the ground with the disc
facing down. This can damage or warp the disc.
Place blocks under the wheel so that the disc does
not touch the ground.
Special Tools - Bearing Remover Head,
Bearing Remover Shaft,
Front Hub Bearing Installation
Before installing the hub bearings, blow any dirt or foreign
particles out of the hub with compressed air to prevent
contamination of the bearings.
Replace the bearings with new ones.
Install the bearings by using the bearing driver set which
does not contact the bearing inner race.
Install the bearings so that the marked side faces out.
Press in the right bearing [A] until it is bottomed.
Special Tool - Bearing Driver Set [B]: 57001-1129
Replace the grease seals with new ones.
Press in the grease seals [A] so that the seal surface is
flush [B] with the end of the hole.
Apply high-temperature grease to the grease seal lips.
Special Tool - Bearing Driver Set [C]: 57001-1129
Install the removed parts (see appropriate chapters).
13 [C]: 57001