Install the following as shown in the figure.
Friction Plates [A] [B]
Steel Plates [C]
Spring Seat [D]
Clutch Hub [F]
The lining blocks [G] of the friction plate [B] are larger
than them of the friction plates [A].
Install the spring seat and spring between first steel
plate and second steel plate.
The inside diameter of second friction plate [B] is larger
than the others because the spring seat and spring are
equipped to decrease the judder noise as shown in the
If new dry friction plates and steel plates are in-
stalled, apply engine oil to the surfaces of each
plate to avoid clutch plate seizure.
Install the last friction plate [A] fitting the tangs in the
grooves in the housing as shown.
Apply molybdenum disulfide grease to the outside surface
[A] of the pusher [B].
Install the pusher into the drive shaft [C].
Apply molybdenum disulfide grease to the needle bearing
[D] and washer [E].
Align the mark [A] of the spring plate [B] with the range
between marks [C] of the sub clutch hub [D] to install the
spring plate on the sub clutch hub.
Install the clutch springs, spring holders, and tighten the
clutch spring bolts.
Torque - Clutch Spring Bolts: 11 N·m (1.1 kgf·m, 97 in·lb)
Install the clutch cover (see Clutch Cover Installation).