Clutch Cover Removal
Drain the engine oil (see Engine Oil Change in the Peri-
odic Maintenance chapter).
Right Middle Fairing (see Middle Fairing Removal in the
Right Lower Fairing (see Lower Fairing Removal in the
Clutch Cover Bolts [A]
Clutch Cover [C]
Clutch Cover Installation
Using a cleaning fluid, clean off any oil or dirt that may be
on the mating surface. Dry them with a clean cloth.
Apply liquid gasket to the area [A] where the mating sur-
face of the crankcase touches the clutch cover gasket and
circumference of the crankshaft sensor grommet.
Sealant - Liquid Gasket, TB1211F: 92104-0004
Replace the clutch cover gasket with a new one.
Install the brackets [A].
Apply a non-permanent locking agent to only one clutch
cover bolt [B] shown in figure.
Tighten the clutch cover bolts following the specified tight-
ening sequence [1 ∼ 19].
Tighten the clutch cover bolts while pushing the clutch
Torque - Clutch Cover Bolts: 12 N·m (1.2 kgf·m, 106 in·lb)
Clutch Cover Disassembly
Clutch Cover (see Clutch Cover Removal)
Clutch Cover Damper Plate Bolts [A]
Clutch Cover Damper Plates [B]
Remove the dampers [A].