5-26 ENGINE TOP END
Cylinder Head Removal
Remove the engine (see Engine Removal in the Engine
Set the engine on a clean surface and hold the engine
steady while parts are being removed.
Cylinder Head Cover (see Cylinder Head Cover Re-
Camshafts (see Camshaft Removal)
Timing Rotor (see Timing Rotor Removal in the Electrical
Rear Camshaft Chain Guide Bolt [A]
Rear Camshaft Chain Guide [B]
Crankshaft Sprocket [C]
Camshaft Chain [D]
Front Camshaft Chain Guide Bolt (Lower) [E]
Front Camshaft Chain Guide Bolt (Upper) [F]
Front Camshaft Chain Guide [G]
Coolant Drain Bolt (Cylinder) [A]
Drain the coolant.
Loosen the M6 and M10 cylinder head bolts as shown
sequence [1 ∼ 12], and remove them and washers.
Remove the cylinder head.
Cylinder Head Installation
The camshaft cap is machined with the cylinder head,
so if a new cylinder head is installed, use the cap that
is supplied with the new head.
Install the dowel pins.
Replace the cylinder head gasket with a new one.
Install the cylinder head.