Install the rubber dampers [A], [B] and collars [C] as
Make sure that the dampers have been fitted in the brack-
Face the large diameter side of the damper to the collar.
Check that the pads [A] are in place on the radiator cover
3 mm (0.12 in.) [C]
If the pads are damage or deteriorated, replace them.
Apply a non-permanent locking agent to the threads of
the radiator cover bolts.
Install the collars and tighten the radiator cover bolts.
Torque - Radiator Cover Bolts: 10 N·m (1.0 kgf·m, 89 in·lb)
Tighten the upper and lower radiator mounting bolts.
Torque - Upper Radiator Mounting Bolts:
kgf·m, 11 ft·lb)
Lower Radiator Mounting Bolt: 10 N·m (1.0 kgf·m,
Run the radiator fan motor leads, main harness and reg-
ulator/rectifier lead (to alternator) correctly (see Cable,
Wire, and Hose Routing section in the Appendix chap-
Install the water hoses and clamps (see Cable, Wire, and
Hose Routing section in the Appendix chapter).
Tighten the water pipe bolt.
Torque - Water Pipe Bolt: 10 N·m (1.0 kgf·m, 89 in·lb)
Install the removed parts (see appropriate chapters).
COOLING SYSTEM 4-17
15 N·m (1.5