Supercharger Chain Tensioner Removal
Throttle Body Assy (see Throttle Body Assy Removal)
Clutch Cover (see Clutch Cover Removal in the Clutch
Supercharger Chain Tensioner Mounting Bolts [A]
Supercharger Chain Tensioner [B]
Supercharger Chain Tensioner Installation
Some noise from the super charger tensioner could oc-
cur when replacing the tensioner or when starting vehi-
cle after long storage. However, if there is no problem
on the function of the tensioner, that noise will disap-
pear after riding for a while.
Opening the snap ring [A], release it and turn the ten-
sioner body [B] clockwise while holding the push rod [C].
Turning the tensioner body clockwise, slide the stopper
[A] into the groove [B] of the push rod [C].
Be careful not to fit the snap ring [D] into the groove.
Replace the gasket [A] with a new one.
Apply a non-permanent locking agent to the supercharger
chain tensioner bolts.
Install the tensioner body [B] slowly, and tighten its bolts.
Torque - Supercharger Chain Tensioner Mounting Bolts:
10 N·m (1.0 kgf·m, 89 in·lb)
FUEL SYSTEM (DFI) 3-69