3-68 FUEL SYSTEM (DFI)
Air Cleaner Housing Installation
Install the blow-off valve hose [A], and tighten its clamp
screw [B] (see Cable, Wire, and Hose Routing section in
the Appendix chapter).
Torque - Blow-off Valve Hose Clamp Screw: 3.0 N·m (0.31
kgf·m, 27 in·lb)
Install the inner plate [C].
Apply a non-permanent locking agent to the inner plate
bolt [D], and tighten it.
Torque - Inner Plate Bolt: 6.0 N·m (0.61 kgf·m, 53 in·lb)
Replace the O-ring [E] with a new one.
Apply grease to the O-ring, and install it.
Using a high flash-point solvent, clean off any oil or dirt
that may be on the liquid gasket coating area. Dry them
with a clean cloth.
Apply liquid gasket to the air cleaner housing.
Liquid Gasket Coating Area [F]
Viewed from S [G]
Sealant - Liquid Gasket, TB1207B: 92104-2068
Install the air cleaner housing, and tighten their bolts.
Insert the breather hose so that the pinch of the clamp [H]
Torque - Air Cleaner Housing Mounting Bolts [I]: 10 N·m
(1.0 kgf·m, 89 in·lb)
Install the removed parts (see appropriate chapters).