Samsung SCU-2370 User Manual page 6

PRECAUTIONS ON INSTALLATION AND USE
Be sure to install the product vertically. Do never place it in other ways or reversely.
For safety reasons to prevent a risk of accidental drop-off, use a strong safety chain while installing
the product.
The wall where you intend to install the product should be fi rm and solid as well as the screws in
order to prevent a risk of drop-off.
Pay special attention to safe transportation. A sudden impact may cause a damage to the product.
When connecting the power, communication, video and lightening device using the cable gland,
seal off the cable gland with a Tefl on tape (PTFE) so that no water can infl ow.
If you need to open the housing for the installation work, be sure to turn off the product before
proceeding.
Use only the provided or rated AC adapter.
Use only power adapter with 24V AC, 6A or higher that satisfi es the power specifi cations.
M 
For product consulting, contact your nearest retailer. Note that servicing may be chargeable for using a special equipment such
as an extension ladder.

This is an assistant device to the monitoring system; the company do not take responsibility for any fi nancial or physical damage
to the product that may occur due to theft, fi re or natural disasters.
CAUTIONS FOR OPERATING TEMPERATURE
1. The camera cannot operate properly at temperatures lower than -50ºC.
2. Even if the surrounding temperature is -50ºC or higher, the camera may not thaw itself and
operate properly depending on the installation environment.
3. Always keep the power on, so the camera can maintain its internal temperature at -10ºC or
higher.
4. If the camera was turned on after being left at temperatures lower than -50ºC for a long duration:
- If the internal temperature is lower than -20ºC, the camera does not transmit video signals
and displays a black screen along with the "Wait to warm up(xx Left)" message, instead of
operating properly.
- If the internal temperature is higher than -20ºC and lower than -10ºC, the "Wait to warm up(xx
Left)" message disappears as the camera resets itself and enters the operation mode.
However, only manual P/T operation is in effect while the Sequence and Turbo commands are
limited in use.
- If the internal temperature is higher than -10ºC, the camera activates all Sequence and Turbo
commands.
6_ important safety instructions