Samsung SCU-2370 User Manual page 48

setup
Area Setting
The Area Setting menu enables selecting certain locations in the course of the Pan and Tilt operation, and then display the
areas with the OSD (On Screen Display) texts when the camera passes through them. Up to 8 areas can be selected.
Area Name :
You can add names to selected areas. Names can be up to 12
characters and can be entered via the joystick and the Enter
key. Once a name is entered, use the joystick and the Enter key
to perform the Set command and save the name.
Edit Area Name 1
[ ]
0123456789 : . ,&/ ►
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
BACK SPACE CLEAR SET
Position :
As shown in the picture below, move the joystick to select the upper
left corner and lower right corner of an area.
START POSITION
ENTER: SET ESC: EXIT
The effective positioning range is between -45° and 40° in the tilting
angle at the zoom factor of 1x.
ON/OFF :
Cancels or activates the display function of selected areas.
M 
Area naming for SCU-9051/VAC/VAC1
START POSITION
ENTER: SET ESC: EXIT
SCU-VAC/VAC1/9051 supports only the pan positioning regardless of the
tilting angle.
setup
48_
%−=[ ] < >
END POSITION
ENTER: SET ESC: EXIT
END POSITION
ENTER: SET ESC: EXIT
Main Menu
Camera Setting
Sequence Setting
P/T Setting
▶
OSD Setting
Alarm Setting
Initialize
Status
P/T Setting
Pan Limit
Tilt Limit
Area Setting
▶
Area Masking
Housing Load 03 KG
Wiper
Prop. P/T ON
Image Hold OFF
Area Setting
▶ Area 1
Area 2
Area 3
Area 4
....
Area 1
Area Name
▶
Position
On/Off OFF