Ignition Timing Inspection
Remove the timing inspection cap [A].
Special Tool - Filler Cap Driver: 57001-1454
Attach the timing light [A] in the manner prescribed by the
Special Tool - Timing Light: 57001-1241
Start the engine and aim the timing light at the ignition
timing mark [B] on the flywheel.
TDC Mark [C]
Run the engine at the speeds specified and note the align-
ment of the ignition timing marks.
Check the engine speed, using the engine revolution
tester for high accuracy.
2 000 r/min (rpm)
If the ignition timing is incorrect, check the crankshaft sen-
sor (see Crankshaft Sensor Inspection).
If the crankshaft sensor are normal, check the C.D.I. unit
(see C.D.I. Unit Inspection).
Install the timing inspection cap.
Torque - Timing Inspection Cap: 3.9 N·m (0.40 kgf·m, 35
Hole groove aligns with:
Line mark on magneto rotor
ELECTRICAL SYSTEM 16-13