Clutch Cover and Right Engine Cover
Engine Oil (see Engine Oil Change in the Periodic Main-
Coolant (see Coolant Filling in the Cooling System chap-
Check the rear brake effectiveness (see Brakes section
in the Periodic Maintenance chapter).
Oil Seal Installation
If the oil seal is removed, replace all of them with
new ones at the same time.
Press in the oil seals direction as shown in the fugure.
Special Tool - Bearing Driver Set: 57001-1129
Press in the new oil seal using a press and suitable tools
so that the seal surface is flush with the surface of the
right engine cover.
Flat Side [A]
Kickshaft Oil Seal [B]
Press the new crankshaft oil passage oil seal [A] so that
the seal surface is flush with the surface of the right engine
Flat Side [B]
Install the circlip [C].
Special Tool - Inside Circlip Pliers: 57001-144
Apply plenty of grease to the oil seal lips.