Table of Contents
Advertisement
3.3
OSD2700F OPERATION
When using the OSD2700F for the first time, check that the unit is in good condition with no visible
damage.
Connect the unit to an appropriate power source and check that the indicators illuminate accordingly on
power up (see Table 4) after all other connections have been made.
3.3.1
CABLE CONNECTIONS
It is necessary to follow the cable specifications below when connecting the switch to your network.
Use appropriate cables that meet your speed and cabling requirements.
Speed
Connector
Copper RJ45
10Base-T
RJ-45
100Base-TX
RJ-45
1000Base-T
RJ-45
SFP
1000Base-SX Duplex LC
1000Base-LX Duplex LC
1000Base-BX Duplex LC
Step 1: First, ensure the power of the switch and end devices are turned off.
Step 2: Prepare cable with corresponding connectors for each type of port in use.
Step 3: Consult Cable Specifications Table on previous page for cabling requirements based on
connectors and speed.
Step 4: Connect one end of the cable to the switch and the other end to a desired device.
Step 5: Once the connections between two end devices are made successfully, turn on the power and
the switch is operational.
PAGE 16
OPTICAL SYSTEMS DESIGN
TABLE 5: CABLE SPECIFICATIONS
Port Speed
Half/Full Duplex
10/20 Mbps
100/200 Mbps
2000 Mbps
2000 Mbps
2000 Mbps
2000 Mbps
OSD2700F OPERATOR MANUAL
Cable
2-pair UTP/STP Cat. 3, 4, 5 100m
2-pair UTP/STP Cat. 5
4-pair UTP/STP Cat. 5
MMF (62.5µm)
SMF (9µm)
SMF (9µm)
Max.
Distance
100m
100m
550m
2km
10, 40, 60km
70km
DOC ID: 10111504
Advertisement
Table of Contents
