Motor Unit - Nikon SB-800 Repair Manual

・Slacken the pink wire.
・Place the pink wire between the rib and guide
pin for arrangement and fix it with tape at 2
positions.
Do NOT attach the tape on the rotating shaft

Motor unit

Procedure
① Assemble the driving pin, screw (#24 and
#14) into the driving mold.
② Tighten the screw (#24) slightly,
then rotate back about one-third turn
counterclockwise.
③ Mount the driving mold on the motor.
④ Insert the guide shaft B.
⑤ Fix the guide shaft B with E-ring.
⑥ Attache the driving mold holder with 2
screws (#56).
⑦ Insert the guide shaft A.
⑧ Attach the tetrone sheet C.
Rib
Guide pin
③ Motor
① Driving mold
② #24
⑧ Tetrone sheet C
#56×2
⑥ Driving mold holder
- A4 ･ SB-800 -
TA-0001
Grease: G7100
④ Guide shaft B
Driving pin
#14
INC
FSA03501-R.3613.A
⑤ E-ring
⑦ Guide shaft A