Canon MX520 series Online Manual page 28

If the problem is not resolved, insert the CD-ROM in the DVD/CD-ROM drive on your computer to start
setting up again, or access our web site through the Internet and download the latest MiniMasterSetup for
your model.
• For placement:
Make sure that there is no barrier or obstacle between the access point and the machine.
Cannot Communicate with the Machine over the Wired LAN
• Check 1: Make sure that the machine is turned on.
• Check 2: Make sure that the LAN cable is connected properly.
Make sure that the machine is connected to the router with the LAN cable. If the LAN cable is loose,
connect the cable properly.
If the LAN cable is connected to the WAN side of the router, the cable is connected to the LAN side of
the router.
If the problem is not resolved, insert the CD-ROM in the DVD/CD-ROM drive on your computer to start
setting up again, or access our web site through the Internet and download the latest MiniMasterSetup for
your model.
Cannot Print or Scan from a Computer Connected to the Network
• Check 1: Make sure that the network settings of the computer are correct.
For the procedures to set up the computer, refer to the instruction manual of your computer or contact
its manufacturer.
• Check 2: If the MP Drivers are not installed, install the MP Drivers.
Install the MP Drivers with the Setup CD-ROM.
• Check 3: When using wireless LAN, make sure that access control is not set to the
access point.
For the procedures to connect an access point and set it up, refer to the instruction manual of your
access point or contact its manufacturer.
Note
To check the MAC address or the IP address of the computer, see
the MAC Address of the Computer.
Checking the IP Address or