Press SEL button (10) to select the desired adjustment mode. The
adjustment mode will change in thefollowing order:
By rotating the knob (10) clockwise or counter-clockwise, it is possible to
adjust the desired sound quality.
Press SEL button (10) for several seconds, it is activated as cyclical mode
of following functions for user's selection.
TA SEEK OR TA ALARM
- TA SEEK mode:
When newly tuned station does not receive TP information for several
seconds, the radio retunes to next station which has not the same station
(PI) as the last station, but has the TP information. When TP information
gets lost at the current station for retune time which is set by RETUNE
SHORT (30 sec.) or RETUNE LONG (90 sec.), the radio start to retune to
next same PI station.
When same PI station doesnot catch in 1 cyclic search, theradio retunes
to next station with TP information.
- TA ALARM mode:
When this mode is selected, any automatic retune mode is not activated.
Only double beep sound (ALARM) is output.
When newly tuned station does not have TP information for several
seconds, beeps come out. When TP information gets lost at the current
station for retune time, the beep sound is out-putted.
When newly tuned station has no RDS signal, "PI SEEK" is suppressed
b) PI SOUND or PI MUTE
While AF switching is implemented in C201 station, AF can switch to 100
MHz, which is non genuine AF (where, different PI with same AF) in short
If a car cruises that critical area back and forth, an oscillation