Advertisement
14.
F
E
I'
15. L
16.
(
17.
$
t
18.
(
F
C
r
C
E
c
I
I'
t
19.
(
20.
F
t
I
vo
L T
outle
namc
for t k
the
tl
voltas
IMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking t o
!e that keys and adjusting wrenches are removed from tool before turning
on.
JOlD UNINTENTIONAL STARTING. Don't carry plugged-in tool with finger
I
switch. Be sure switch is OFF when plugging in.
UTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only
:tension cords intended for use outdoors and
so
marked.
T A Y ALERT. Watch what you are doing, use common sense. Don't operate
01 when you are tired.
HECK DAMAGED PARTS. Before further use of the tool, a guard or other
irt that is damaged should be carefully checked t o determine that
it
will
ierate properly and perform its intended function. Check for alignment of
oving parts, binding of moving parts, breakage of parts, mounting, and any
her conditions that may affect its operation. A guard or other part that
damaged should be properly repaired or replaced by an authorized serv-
e center unless otherwise indicated elsewhere in this instruction manual.
w e defective switches replaced by authorized service center. Don't use
01 if switch does not turn
it on
and off.
UARD AGAINST ELECTRIC SHOCK. Prevent body contact with grounded
irfaces. For example; pipes, radiators, ranges, refrigerator enclosures.
!PLACEMENT PARTS. When servicing, use only identical replacement parts.
,GE WARNING: Before connecting the tool t o a power source (receptacle,
etc.) be sure the voltage supplied is the same as that specified on the
)late of the tool. A power source with voltage gr.eater than that specified
!
tool can result in SERIOUS INJURY t o the user
-
as well as damage t o
01. If in doubt, DO NOT PLUG IN THE TOOL. Using a power source with
e
less than the nameplate rating is harmful t o the motor.
3
Advertisement
