Menu Tools - NEC MultiSync LCD2470WNX User Manual

Controls
DDC/CI: Tuns on or off the two-way communication between the graphics card and
the monitor. With DDC/CI turned on, some monitor settings can be adjusted through
the graphics card using a computer.
FACTORY PRESET: Selecting Factory Preset allows you to reset all OSM control set-
tings back to the factory settings. The RESET button will need to be held down for
several seconds to take effect. Individual settings can be reset by highlighting the
control to be reset and pressing the RESET button.

Menu Tools

LANGUAGE: OSM
OSM LEFT/RIGHT: You can choose where you would like the OSM control
image to appear horizontally on your screen.
OSM DOWN/UP: You can choose where you would like the OSM control image to
appear vertically on your screen.
OSM TURN OFF: The OSM control menu will stay on as long as it is in use. In the
OSM Turn Off submenu, you can select how long the monitor waits after the last
touch of a button to shut off the OSM control menu.
OSM LOCK OUT: This control completely locks out access to all OSM control func-
tions except Brightness and Contrast. When attempting to activate OSM controls
while in the Lock Out mode, a screen will appear indicating the OSM controls are
locked out. To activate the OSM Lock Out function, press SELECT, then right control
button and hold down simultaneously. To deactivate the OSM Lock Out, press SE-
LECT, then left control button and hold down simultaneously while in the OSM menu.
RESOLUTION NOTIFIER: If this option is ON, a message will appear on the screen
after 30 seconds notifying the user that the optimal resolution is not being used. The
optimal resolution is 920 x 200.
Information
The Information menu indicates the current input, display resolution, horizontal and
vertical frequency, and polarity settings of the monitor. The model and serial numbers
of your monitor are also indicated.
OSM Warning: OSM Warning menus disappear with Exit button.
®
NO SIGNAL: This function gives a warning when there is no signal present.
After power is tuned on or when there is a change of input signal or video is inac-
tive, the No Signal window will appear.
RESOLUTION NOTIFIER: This function gives a warning if a resolution other than
the optimal resolution is used. After power is turned on or when there is a change of
input signal or the video signal doesn't have proper resolution, the Resolution Notifier
window will open. This function can be disabled in the Menu Tools.
OUT OF RANGE: This function gives a recommendation of the optimized
resolution and refresh rate. After the power is turned on or there is a change of input
signal or the video signal does not have proper timing, the Out Of Range menu will
appear.
• For Advanced Menu options for the see page 8.
- continued
control menus are available in eight languages.
®
2