Download Table of Contents Print this page

Programming The Water Softener - Whirlpool WHES60 Installation And Operation Manual

Demand controlled water softener

Advertisement

Table of Contents

Programming the Water Softener

RECHARGE button
Display
PROGRAM THE SOFTENER
When the power supply is plugged into the electrical
outlet, the model code (LL60) and a test number
(example: J3.8), are briefly shown in the display.
Then the words "PRESENT TIME" appear and 12:00
PM begins to flash.
SET TIME OF DAY
If the words "PRESENT TIME" do not show in the dis-
play, press the PROGRAM button until they do.
s
1. Press the
UP or
present time. Up moves the display ahead; down
sets the time back. Be sure AM or PM is correct.
NOTE: Press buttons and quickly release to slowly
advance the display. Hold the buttons down
for fast advance.
Questions? Call Toll Free 1-866-986-3223
When you call, please be prepared to provide the model and serial number,
found on the rating decal, located on the back of the controller's top cover.
PRESS TO SCHEDULE
HOLD TO START
DOWN buttons to set the
FIG. 17
or visit www.whirlpoolwatersofteners.com
RECHARGE
PROGRAM
DATA
SET WATER HARDNESS NUMBER
1. Press the PROGRAM button once again to display
a flashing "25" and the word "HARDNESS".
2. Press the
water's hardness number.
NOTE: If your water supply contains iron, compen-
sate for it by adding to the water hardness
number. For example, assume your water is
20 gpg hard and contains 2 ppm iron. Add 5
to the hardness number for each 1 ppm of
iron. In this example, you would use 30 for
your hardness number.
2 ppm iron x 5 = 10 +10
(times)
3. Press the PROGRAM button once again to return
to normal operating display.
Monday- Friday, 8 AM - 7 PM EST
12
UP button
PROGRAM button
DOWN button
DATA button
FIG. 16
s
UP or
DOWN buttons to set your
20 gpg hardness
30 HARDNESS NUMBER
continued on next page
FIG. 18

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents