Installing or removing the saw
Always be sure that the tool
switched off and unplugged before installing or removing
To install the blade, loosen the screw on
With the blade teeth facing forward, insert
the blade into the blade holder as far as
will go. Make sure that the back edge of
the blade fits properly in the groove of the
roller. Then firmly tighten the screw to
secure the blade.
Jig saw balde
*Always secure the blade firmly. Insufficient securing of the blade may cause blade
breakage or serious injury.
Always clean out the blade holder before installing the blade. Chips or foreign matter on
the blade holder may cause insufficient securing of the blade.
*Use a lubricant or cutting oil between the blade and roller when cutting iron or com-
position board, etc. Failure to do so will shorten the service life of your blade and roller
or lead to potentially dangerous blade breakage.