ADDITIONAL SAFETY RULES
Avoid cutting nails. Inspect for and remove all nails from the workpiece before
Don't cut hollow pipe.
Do not cut oversize workpiece.
4. Check for the proper clearance beneath the workpiece before cutting so that
Always wear eye protection conforming
current national standard.
Hold the tool firmly.
Make sure cord is out of your way and not in the line of cut.
Make sure the blade is not contacting the workpiece before the switch is
Keep hands away from moving parts.
the blade will not strike the floor, workbench, etc.
Severe eye injury could result.
When cutting through walls, floors or wherever "live" electrical wires may
be encountered, DO NOT TOUCH ANY METAL PARTS
Hold the tool only by the insulated grasping surfaces t o prevent electric shock
if you cut through a "live" wire.
1 1 .
Do not leave the tool running. Operate the tool only when hand-held.
Always switch off and wait for the blade t o come t o a complete stop before
Do not touch the blade or the workpiece immediately after operation; they
removing the blade from the workpiece.
may be extremely hot and could burn your skin.