To trim edges or make slight dimensional adjustments, run the blade lightly along the cut
Always use a suitable coolant (cutting oil) when cutting metal. Failure to do so will cause
significant blade wear. The underside of the workpiece can be greased instead of using a
Plastic base plate
Use the plastic base plate when cutting
decorative veneers, plastics, etc. It protects
sensitive or delicate surfaces from damage.
To replace the base plate, remove the four
screws with the hex wrench.
To reduce the potential for workpiece sur-
face splintering, the anti-splintering device
can be used. Fit
into the base from
below so that
surrounds the sides of the