Advertisement
Available languages
Available languages
ishwasher
ispenser & Detergents
Rinse Aid
Rinse aid greatly improves drying, reduces water
spots, filming, and lubricates wash arm bearing for
proper rotation. With it water "sheets" off dishes
rather than forming water droplets that cling and
leave spots.
A dispenser, located next to the detergent cup,
automatically releases a measured amount of rinse
aid during the last rinse. If spotting and poor drying
are problems, increase the amount of rinse aid
dispensed.
The indicator will be dark when full and
will show clear when it is time to refill.
To add liquid rinse aid, open the cover. Pour in
rinse aid until liquid touches the indicated fill level.
Close the cover.
Do not overfill since this can cause oversudsing.
Wipe up any spills with a damp cloth.
The dispenser holds enough for 11 to 66 washes,
depending on setting.
O
Indi
o
cator
__.._L}
0
__
Rinse Aid
_
Compartment
Rinse Aid
-----J
cover
Not selecting
the AIR DRY option
in
combination
with rinse aid will enhance drying
performance.
The energy required to use the
AIR DRY option saves pennies per cycle. You
may choose to select the AIR DRY option;
however you will have items in your dish load
that will not be completely dry at the end of the
cycle.
How to adjust the rinse aid dosage
The rinse aid dosage is indicated by the flashing
of LEDs: HFTEMP, SANITIZE, AIR DRY and MAX
DRY. Press and hold the RINSE pad for 5 seconds
untilone of the following combinations of LEDs are
flashing:
Level 1: HI-TEMP LED flashes
Level 2: HI-TEMP and SANITIZE LEDs flash
Level 3: HI-TEMP, SANITIZE and AIR DRY LEDs
flash
Level 4: HFTEMP, SANITIZE, AIR DRY and MAX
DRY LEDs Flash
Pressing "DELAY" pad changes the Level. Once
the Rinse-Aid Level reaches 4, the level will loop
back to level 1.
Factors
Affecting Performance
Water
Pressure
The hot water line to dishwasher must provide
water pressure between 20 and 120 psi.
Low water pressure may occur when laundry or
showers are in operation.
If you experience poor
wash performance you may need to wait until water
use is reduced before starting dishwasher.
Water Tern perat u re
Hot water is needed for best dishwashing and
drying results. Water entering dishwasher should
be at least 120°F (49°C) to give satisfactory results.
To check water temperature entering dishwasher:
Turn on hot water faucet nearest dishwasher
for several minutes to clear cool water from
pipes.
Hold a candy or meat thermometer
in the water
stream to check the temperature.
•
If temperature is below 120°F (49°C), have
a qualified person raise the hot water heater
thermostat setting.
Advertisement
