KitchenAid KVUB606DSS0 Installation Instructions And Use & Care Manual page 10

7=
8.
Remove the rear insulation panel and set it aside.
Using a T20 Torx adapter, remove the 4 screws holding the
blower motor in place. Push up on the blower motor to
disengage the tabs from range hood cavity back. Remove the
blower motor and set it aside.
10. Install the blower motor assembly into the range hood and
secure with the 4 screws supplied with rear motor mounting
bracket assembly.
A
9.
A
A. Range hood
canopy (inside top)
B. Blower motor
C. Blower motor
mounting screws
Install the blower motor onto the rear motor mounting bracket
(purchased separately; see "Accessories or Service" section
to order). Engage the motor mounting tabs into keyhole slots
in rear mounting bracket and push down to secure. Install the
4 screws removed in Step 7 and tighten to secure motor
bracket.
D
B
C
A. Rearmotor mounting
bracket
B. Motor mounting tabs
(2)
C. Blower motor
D. Blower motor
mounting screws (4)
A. Range hood
canopy (inside top)
B. Blower motor
mounting screws
C. Rear blower motor
mounting bracket
assembly
11. Reconnect blower motor electrical connector to the electrical
box connector.
12. Reinstall the rear insulating panel.
13. Reinstall the motor cover plate to range hood using the 4
screws removed in Step 3.
14. Reinstall bottom panels assembly to range hood using the 8
screws removed in Step 2.
Install Range Hood to Cabinet
1. Remove the round knockout from the top or back of the
range hood (depending on your wiring location) for the
wiring strain relief and install a 1/2"UL listed or CSA
approved strain relief.
A
A. Round knockout
2. Using 2 people, lift range hood into final location. Feed
enough electrical wire through the strain relief to make
connections in the terminal box. Tighten the strain relief
screws.
3. Position the range hood so that the large end of the keyhole
slots are over the mounting screws. Then push the hood
toward the wall so that the screws are in the neck of the slots.
The hood should be against the wall. Tighten the mounting
screws, making sure mounting screws are in the narrow neck
of the slots.
4. Check that damper, if used, rotates up and down freely.
5. Connect ventwork to hood. Seal joints with clamps to make
secure and airtight.
10