Advertisement
Advertisement
To replace your water filter:
If your refrigerator is not cooling properly, consider the following reasons and solutions:
If your refrigerator is not producing ice, consider the following reasons and solutions:
If your refrigerator is not cooling, consider the following:
You should generally change the water filter every six months to ensure the highest possible water quality. The Water Filter Status indicator on the user interface will prompt you to replace the filter after a standard amount of water (200 gallons/757 liters) has flowed through the system.
If your freezer compartment is not freezing properly, consider the following reasons and solutions:
If your refrigerator section is not cooling but the freezer is working, consider the following reasons and solutions:
If your refrigerator is not dispensing water, consider the following reasons and solutions:
Your refrigerator running constantly can be normal under certain conditions:
Your refrigerator is compatible with PureSource Ultra™ Water Filter Part# ULTRAWF and PureSource 3™ Water Filter Part #WF3CB.
If your refrigerator is equipped with a PureSource 3™ water filter, it can be replaced with a PureSource Ultra™ water filter. If your refrigerator is equipped with a PureSource Ultra™ water filter, it must be replaced with PureSource Ultra™ water filter ULTRAWF.
To clean the condenser, which can cause the refrigerator to run too much or too long, you should clean the toe grille area:
The dispensed water is not cold. For colder water, you should add crushed ice or cubes before dispensing water.
If warmer tap water goes through the filter and enters the water tank, the chilled water is pushed through to the dispenser. Once the chilled water is used up, it will take several hours to bring the freshly replaced water to a cooler temperature.
Your refrigerator may beep due to several alarms:
To mute alarms (except 'power fail'), press and hold the 'freezer temperature up' key while also pressing the 'fresh food temperature down' key three times. This sequence must be completed within 5 seconds.
To make your refrigerator colder, adjust the temperature settings:
When changing control settings, wait 24 hours for the temperature to stabilize before making additional changes.
To clean the interior of your refrigerator, you should wipe up any spills immediately and clean the freezer and fresh food compartments at least twice a year. Use soap and water or baking soda and water.
For a baking soda solution, use two tablespoons of baking soda in one quart of warm water. Be sure to wring excess water out of the sponge or cloth before cleaning around controls, the light bulb, or any electrical part.
To adjust the freezer temperature, use the Up (Cold) or Down (Colder) buttons closest to the display on the temperature control panel. The first time you press a button, the display will show your current setting. Each subsequent press of the button will change the setting by one. The display will momentarily show your new setting, then return to the current temperature.
For example:
To set the temperature on your refrigerator, use the Up (Cold) or Down (Colder) buttons closest to the display on the temperature control panel. The first time you press a button, the display will show your current setting. Each subsequent press of the button will change the setting by one. The display will momentarily show your new setting, then return to the current temperature.
For example:
If items are freezing in the refrigerator section, the Freezer control might be set too cold. To resolve this, set the Fresh Food control to a warmer setting until the refrigerator temperature is satisfactory, and allow 24 hours for the temperature to stabilize.
If the interior light is not working, you should replace the light bulb:
To turn on the ice maker:
To unlock the control panel, specifically the dispenser lock, press the LOCK Touch Pad for 3-5 seconds until the red light above the Touch Pad goes out.
To clean the exterior stainless steel finish:
To turn on your refrigerator for the first time:
To remove the doors of your refrigerator:
To remove the refrigerator top hinge cover:
To remove the refrigerator door:
To remove the freezer top hinge cover:
To remove the freezer door:
To remove a shelf from your refrigerator:
To properly level your refrigerator:
Need help?
Do you have a question about the FFHS2622MSS and is the answer not in the manual?
Questions and answers
Trying to get it to defrost mode
To set the Frigidaire FFHS2622MSS refrigerator to defrost mode, press the light button inside the fridge 5 times within 6 seconds.
This answer is automatically generated