Advertisement
Installation
ADDING ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
, Insert the elbow through the rear opening and connect
it to the dryer internal duct.
. Apply duct tape on the joint between the dryer internal
duct and elbow, as shown on page 7.
CAUTION:
Internal duct joints must be secured with tape,
otherwise they may separate and cause a
safety hazard.
ADDING COVER PLATE TO REAR OF
CABINET
(KITWEII454)
Connect standard metal elbows and ducts to complete
the exhaust system. Cover back opening with a plate (Kit
WE1M454) available from your local service provider. Place
dryer in final location.
WARNING - NEVER LEAVE THE
BACK OPENING WITHOUT THE PLATE.
Instructions
F_CHANGING DIRECTIONOF DOOR OPENING
1. Open the door and remove the filler plugs opposite the
hinges. With the door completely open, remove the
bottom screws from each hinge on the dryer face. Insert
these screws about half way into the TOP holes, for each
hinge on the opposite side (where you removed the filler
plugs). Apply firm pressure to get the screws started.
REMOVE 4 PLUGS AND KEEP
FOR INSERTION
INTO
THE OPPOSITE
SIDE
REMOVE BOTTOM
SCREW FROM EACH HINGE
AND INSTALL HALF WAY INTO EACH TOP OF
OPPOSITE HINGE HOLES
._f"_-_*-_
!,i
t
2. Loosen the top screws from each hinge on the dryer
face halfway. With one hand holding the top of the door
and the other hand holding the bottom, remove the
door from the dryer by lifting it UP and OFF.
LOOSEN EACH TOP HINGE
.j_'_,.
_
_-__
REE oTJW ?o
LIFT
/
\
3. Remove the blind plate from
the hinge side of the dryer
by removing its two screws. _:,_
Remove the
strike plate :;
from the opposite side
of
the
sTRiK_
/BLIND
dryer by removing its two PLATE:
screws. Reinstall the plates,
FRONTPANEL
on the opposite sides, using
two screws in each plate.
4. Rotate the door 180 °. Insert the door on the opposite
side of the opening by moving the door ON and DOWN
until the top hinge and the bottom hinge are resting on
the top screws inserted in step 1.
o
ROTATE DOOR 180
AND HANG
IT ON TOP HINGE SCREWS
5. Remove the remaining screws from the side of the
opening from which the door was removed. With these
screws secure each hinge at the bottom. Tighten the
two top screws on each hinge. Reinsert the plastic plugs
on the side from which the door was removed.
INSTALL AND TIGHTEN BO]q-OM
"_X
SCREWS AND TIGHTEN TOP
INSERT PLUGS
INTO HOLES ON
OPPOSITE
SIDE
8
Advertisement
