Frigidaire FCCS071QWA Instructions Manual page 4

First Steps
The following tools are required to assemble and install the casters to the unit:
A Wrench (1) _ _
B Screws (16) _ _ _
C Casters (4)
Caster Set-up
1. With an assistant, tilt the unit until it is resting on its back. Take care to protect the back from
being scratched during this process.
2. Using the wrench provided and the sixteen (16) screws, install all four (4) casters in the tapped
holes in the bottom of the unit. Tighten the screws securely.
3. With an assistant, tilt the unit back up onto its casters.
4. To prevent unintended movement, block casters once the unit is in place.
Appliance Placement
Leave a three (3) inch space on all sides and the back of the cabinet for ease of installation, proper air
circulation and electrical connections. Choose a place that is near a grounded electrical outlet. For the
most efficient operation, the appliance should be located where surrounding temperatures will not drop
below 40OF (5oc) or exceed 110OF(43oc). Additional compressor heaters are not recommended.
Insulation
The insulated space of this cabinet is sealed to maintain peak efficiency. DO NOT drill holes in the
cabinet. Holes drilled in the cabinet may destroy that seal and damage electrical wiring located in the
insulated space. It may also pierce and damage the sealed refrigeration system in the insulated space.
DAHAGED ELECTRICAL WIRING OR WET INSULATION CAUSED BY DRILLING WILL VOID
THE WARRANTY,
Glass Lid Hodels
• There are two (2) glass lids, a smaller one that fits in the lower track of the ice cream freezer
and a larger one that fits in the upper track. The lower track has two (2) round retaining studs
and the upper has four (4) round retaining studs.
Install the lower glass first. Again, the lower glass is the smaller of the two. It has a flexible vinyl
seal and a lock plate. The flexible seal should be facing up and positioned on the end away from
the two round retaining studs. Place the panel in the center and slide along the lower track until it
is secure under the two retaining studs.
Place the upper glass panel over the lower glass panel already in place. Slide it over the lower
lid past the flexible seal. You will notice a slight resistance with the lower lid gasket. Slide the
upper panel under the four studs on the upper track of the frame.
When properly installed, there is a seal formed by the flexible vinyl seal between the two glass lids.
4