1
2
1. Lock nut
2. Templet guide
3. Router bit
4. Base plate
1
2
3
4
1. Router bit
2. Base
3. Templet
4. Workpiece
5. Templet guide
6. Lock nut
MAINTENANCE
1. Limit mark
12
To install the templet guide, insert the templet guide in center
003799
hole in the base plate and secure in place with the lock nut.
4
3
Secure the templet to the workpiece. Place the tool on the
003696
6
templet and move the tool with the templet guide sliding
along the side of the templet.
5
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
1