Makita RP1100 Instruction Manual page 11

1. Hex socket bolts
2. Straight guide
• When using the straight guide, be sure to install it on the
right side in the feed direction. This will help to keep it
flush with the side of the workpiece.
Straight guide (optional accessory)
003679
The straight guide is effectively used for straight cuts when
1
chamfering or grooving.
To install the straight guide, insert the guide bars into the
holes in the tool base. Adjust the distance between the bit
and the straight guide. At the desired distance, tighten the
2
hex socket bolts to secure the straight guide in place.
When cutting, move the tool with the straight guide flush with
003685
the side of the workpiece.
If the distance between the side of the workpiece and the
003686
cutting position is too wide for the straight guide, or if the side
of the workpiece is not straight, the straight guide cannot be
used. In this case, firmly clamp a straight board to the work-
piece and use it as a guide against the base. Feed the tool in
the direction of the arrow.
Templet guide (optional accessory)
003690
The templet guide provides a sleeve through which the bit
passes, allowing use of the tool with templet patterns.
11