GE GTDP180ED4WW Installation Instructions Manual page 7

Installation instructions
. Apply duct tape as shown on the joint between the
dryer internal duct and the elbow.
DUCT
CAUTION:
Internal duct joints must be
secured with tape, otherwise
H hey may separate and cause
a safety hazard.
ADDING ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
. Insert the elbow through the rear opening and connect
it to the dryer internal duct.
. Apply duct tape on the joint between the dryer internal
duct and elbow, as shown on page 6.
J
CAUTION:
Internal duct joints must be secured with tape,
otherwise they may separate and cause a
safety hazard.
ADDING COVER PLATE TO REAR
OF CABINET {SIDES AND BOTTOM
EXHAUST}
PLATE
(KffWE1M454)
Connect standard metal elbows and ducts to complete
the exhaust system. Cover back opening with a plate
(Kit WE1M454) available from your local service provider.
Place dryer in final location.
WARNING-NEVER
LEAVE THE BACK
OPENING WITHOUT THE PLATE. (Kit
WEIM454)
[_CHANGING DIRECTIONOF DOOROPENING
1.Open the door and remove the filler plugs opposite the
hinges. With the door completely open, remove the
bottom screw from each hinge on the dryer face. Insert
these screws about half way into the TOP holes, for each
hinge on the opposite side (where you removed the filler
plugs). Apply firm pressure to get the screws started.
REMOVE/4 PLUGS AND KEEP REMOVE BOTTOM SCREW FROM EACH HINGE
FOR INSERTION INTO AND INSTALL HALF WAY INTO EACH TOP OF
THE OPPOSITE SIDE
OP ....
2. Loosen the top screw from each hinge on the dryer face
halfway. With one hand holding the top of the door and
the other hand holding the bottom, remove the door
from the dryer by lifting it UP and OFF.
LOOSEN EACH TOP HINGE
SCREW HALF WAY AND LIFT
THE DOOR UP AND OFF
3.
4.
Removethe blind plate from
the hinge side of the dryer
by removing its two screws.
Remove the strike plate
from the opposite side of the
dryer by removing its two
screws. Reinstall the plates,
on the opposite sides, using
two screws in each plate.
Rotate the door 1800. Insert the door on the opposite
side of the opening by moving the door OI/and DOWN
until the top hinge and the bottom hinge are resting on
the top screws inserted in step 1.
ROTATE DOOR 180 ° AND HANG
5. Remove the remaining screws from the side of the
opening from which the door was removed. With these
screws secure each hinge at the bottom. Tighten the
two top screws on each hinge. Reinsert the plastic plugs
on the side from which the door was removed.
INSTALL AN D TIGHTEN BOTTOM
SCREWS AND TIGHTEN TOP
INSERT PLUGS
INTO HOLES ON
OPPOSITE SI DE
7