Frigidaire CGEF308TNF2 Use And Care Manual page 9

SINGLE RADIANT ELEMENT
' The cooktop provides single
radiant element located as
illustrated. Use the following
instructions when operating
these elements.
\
The suggested power level settings shown in Fig. 1 are
based on cooking with medium sized aluminum pans with
lids. Be sure to make any further setting adjustments for
best surface cooking results.
Suggested element power level settings table
...... Se !,g..............................................
High (8.0 - Hi) Start most foods, bring water to a
boil, pan broiling.
Medium high Continue a rapid boil, fry, deep fat fry.
(5.0-8.0)
Medium (3.0 - Maintain a slow boil, thicken sauces
5.0) and gravies or steam vegetables.
Medium Low Keep foods cooking, poach, stew (2.8
(2.0 - 3.0) or lower is a simmer setting).
Low (Lo - 2.0) Keep warm, melt, simmer (2.8 or
lower is a simmer setting).
Fig. I
Not Element Indicator Message
After using any of the radiant element positions the
cooktop will become very hot. Even after setting the
controls to OFF, the cooktop will remain hot for some
time. The cooktop control monitors the temperature
of the cooktop and displays the message "HE" (hot
element) warning when the cooktop is still too hot to
touch. If the HE message appears in the window, the
control can still be turned on again for use.
- Radiant surface elements may appear to have cooled
after they have been turned off. The glass surface
may still be hot and burns may occur if the glass
surface is touched before it has cooled sufficiently.
= Do not place aluminum foil, plastic items such
as salt and pepper shakers, spoon holders or
plastic wrappings on top of the range when it is
in use, These items could melt or ignite. Potholders,
towels or wooden spoons could catch fire if placed
too €lose to the surface elements: .....................................................................................................................................
To Operate the Single Radiant Surface Elements:
1. Place correctly sized cookware on the radiant surface
element.
.
.
.
.
Touch and hold the on-off pad for
the desired element position until
a beep is heard. The display will
show "=="
Note: If no further pads are
touched within 10 seconds the
request to power the element ON
will clear.
Touch hi pad once to turn ON the
power level to Hi.
Touch Io pad once to turn ON the
power level to Low.
Touch meal pad once to turn ON the power level to 5.0.
Each touch of the hi or Io pad will decrease or
increase the power level from Hi through 3.0 by .5
increments. Simmer power levels between 3.0 and 1.2
will decrease or increase by .2 increments. Lo is the
lowest power level available.
Note: The power level may be adjusted at any time
while the element is ON.
When cooking has been completed touch the on-off
pad once to turn the element OFF.
Important notes."
- Start most cooking operations on a higher setting and
then turn to a lower setting to finish cooking.
- For efficient cooking, turn the surface element OFF
several minutes before cooking is complete. This will
allow residual heat to complete the cooking process.
- A glowing red surface heating area extending beyond
the bottom edge of the cookware indicates the
cookware is too small for the surface heating area.
- Radiant elements have a limiter that allows the radiant
heating element to cycle ON and OFF, even at the HI
setting. This helps prevent damage to the ceramic
cooktop. Cycling at the HI setting is normal and will
occur more often if the cookware is too small for the
radiant element or if the cookware bottom is not fiat.