Advertisement
Charging
Connect the charging plug t o the charging
connector, then plug in the charger to the
power receptacle. Charging takes 3 hours.
CAUTION :
0The battery in your new tool i s not fully charged. You will need to charge
it
before use.
0
Do
not operate the tool during charging.
0
Overcharging more than
2
days considerably shortens the battery service life. Always
unplug the charger after completing the charge.
When you charge
a
new tool or
a
tool which has not been used for
a
long period,
it
may
not accept a full charge. This is a normal condition and does not indicate a problem.
You can recharge the tool fully after discharging
it
almost completely a couple of times.
Installing bit
To install the bit, insert it into the tool
as
far
as
it will go.
Switch action
To start the tool, move the slide switch
forward. Release it to stop.
Slide
switch
6
Advertisement
