KitchenAid KDRS505XSS04 Installation Instructions Manual page 9

3=
Determine and mark edge of range in the cutout space. The
mounting bracket can be installed on either the left side or
right side of the cutout. Position mounting bracket in cutout
so that right (or left) edge of the bracket is 15/16" ( 2.4 cm) from
the marked edge of the range, as shown.
A
B
A. Anti-tip bracket
B. Mark edge of range.
C. 1_,, (2.4 cm)
4=
5=
Drill two V8" (3.0 mm) holes that correspond to the bracket
holes of the determined mounting method. See the following
illustrations.
Floor Mounting Wall Mounting
A B
- B
A. #12 x 15_,, s crews A. #12 x 15_,, s crews
B. Anti-tip bracket B. Anti-tip bracket
Using a Phillips screwdriver, mount anti-tip bracket to the wall
or floor with the two #12 x 1%" screws provided.
Power Supply Cord Direct Wire
Electrical Shock Hazard
Disconnect power before servicing.
Use a new 40 amp power supply cord.
Plug into a grounded outlet.
Failure to folow these instructions can result in death,
fire, or electrical shock.
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge copper or 6 gauge aluminum wire.
Electricaly ground range.
Failure to folow these instructions can result in death,
fire, or electrical shock.
1=
2.
Disconnect power.
Use Phillips screwdriver to remove the terminal block cover
screw located on the back of the range. Pull cover down and
toward you to remove cover.
3=
Remove plastic tag holding three 10-32 hex nuts from the
middle post of the terminal block.