4. Addstrain relief.
Style 1: Power supply cord strain relief
h
Assemble a UL listed strain relief in the opening.
.... :::: : ::::: ......
i
H
A
ij
/ ........ \
r
i
,
r_::_
.........
i;
'_
/
_ ,,}.............
L_:( . .....
_:
q ,
_.-------P._
A. UL fisted strain relief
Feed the power supply cord through the strain relief in the
cord/conduit
plate on bottom of range. Allow enough
slack to easily attach the wiring to the terminal block.
•
Tighten strain relief screw against the power supply cord.
Replace cord/conduit
plate and insert screws.
Assemble a UL listed conduit connector in the opening.
Style 2: Direct wire strain relief
•
Use Phillips screwdriver to remove screws and slide
cord/conduit
plate down and out.
f ..............
•
Position cord/conduit
plate as shown in the following
illustration.
A. Removable retaining nut
B. Strain relief
Feed the flexible conduit through the strain relief, allowing
enough slack to easily attach wiring to the terminal block.
Tighten strain relief screw against the flexible conduit.
5. Replace back panel and screws on rear of range.
10