Advertisement
JOINTER FUNCTIONS:
Extension support table
The extension support table i s convenient
for cutting long workpieces. Install it on
the outfeed table and semi-tighten the four
hex bolts. Extend the
legs
and hook the
arms over the screw using the hook
(A).
Then tighten the screws securely. Adjust
the table height using the knobs so that the
extension support table i s level with the
outfeed table. Then tighten the wing nuts
securely. After adjusting the table height,
tighten the four hex bolts securely.
When moving the tool, fold the extension
support table as follows.
First fold the extension support table
as
shown in the figure. Tighten the two hex
bolts securely. While holding the legs,
loosen the screws and unhook the arms
from the screw. Fold the legs and hook the
arms over the screw using the hook
(6).
Then tighten the screws securely.
Adjusting the depth
of
cut
The depth of cut can be adjusted from
0 mm to 3 mm (1/8"). Align the pointer to
the desired graduation on the scale plate by
turning the depth adjusting knob. The in-
feed table i s
lowered for increased depth of
cut by turning i t clockwise and raised by
turning i t counterclockwise.
I
Extension support table
7
Hex bolts
Hook (A)-,
1
-
Arm
Screw
V I
I
;
H
e
x
bolt
Scale plate
1
L
Depth adjusting knob
9
Advertisement
