Kenmore 110.77102310 Installation Instructions Manual page 9

Connect ground wire (F) (green or bare) of power supply cord
to external ground conductor screw (A). Tighten screw.
Remove center terminal block screw (B).
Connect neutral wire (white or center) (C) of power supply cord
to center terminal block screw (B). Tighten screw.
Connect remaining wires to outer terminal block screws.
Tighten screws. Finally, reinsert tab of terminal block cover into
slot of dryer rear panel. Secure cover with hold-down screw.
Now, go to "Venting Requirements."
3-wire Power Supply Cord Connection
Use where local codes permit connecting cablnet-ground
conductor to neutral wire.
A
C
D
E
Q
A. 3-wire receptacle (NEMA type IO-30R)
B. 3-wire plug
C. Neutral prong
D. Spade terminals with upturned ends
E. 3/4" (19 mm) UL listed strain relief
F. Ring terminals
G. Neutral (white or center wire)
Connect remaining wires
Connect remaining wires to outer terminal block screws. Tighten
screws. Finally_ reinsert tab of terminal block cover into slot of
dryer rear panel. Secure cover with hold-down screw. Now, go
to "Venting Requirements."