Download Print this page

Kenmore ULTRACLEAN 665.1281 Series Use & Care Manual page 12

Hide thumbs Also See for ULTRACLEAN 665.1281 Series:

Advertisement

Available languages

Available languages

Powders and Gels
Water
Soil
Pre-Wash
Main Wash
Hardness
Level
Compartment
Compartment
Soft
Light
None
1/2
(0-4 grains
Normal
None
1/2
per U.S.
gallon)
Heavy
Full
1/2
Medium
Light
None
1/2
(5-9 grains
Normal
1/2
1/2
per U.S.
gallon)
Heavy
Full s
Full s
Hard
Light
1/2
Fulls
(10-14 grains
Normal
Full s
Full s
per U.S.
gallon)
Heavy
Full s
Full s
_Full pre-wash compartment
contains 7 tsp (35 mL), and full
main wash cup contains 9 tsp (45 mL).
IMPORTANT:
Extremely hard water mineral deposits (15 grains
per U.S. gallon or more) can cause damage to your dishwasher
and make it difficult to achieve good results. A water softener is
recommended
to avoid damage and achieve good results. You
may bring your water samples to Sears to check hardness level.
.._#__"._,_0 I!i_
I
rj Leck
t'_ Full
'
'i
IMPORTANT" Your dishwasher is designed to use a liquid rinse
aid. The use of rinse aids greatly improves drying by allowing
water to drain from the dishes after the final rinse. They also
keep water from forming droplets that can dry as spots or
streaks.
Filling the dispenser
The dispenser holds 5 oz (150 mL) of rinse aid. Under most
conditions this will last 1 to 3 months.
1. Turn the knob to the REFILL position and remove.
2. Pour rinse aid into the opening until the indicator
points to
FULL. Do not overfill.
3. Clean up any spilled rinse aid. Spilled rinse aid can create
excessive suds.
4. Replace the knob and turn to the LOCI( position.
NOTE: Indicator reads correct fill level when door is completely
opened.
Rinse Aid Setting
Your rinse aid dispenser is adjustable. For most water conditions,
the factory setting will give good results. If you have hard water
and notice calcium buildup on your dishware, you may want to
try a higher setting. If you notice foam in your dishwasher, use a
lower setting.
To adjust the setting
1. Turn the knob to the REFILL position and remove.
2. Turn the arrow inside the dispenser to the desired setting.
3. Replace the knob and turn to the LOCI( position.
12

Advertisement

loading

This manual is also suitable for:

Ultraclean 665.1283 series