Makita 3708FC Instruction Manual page 10

1
2
1. Base
2. Wing bolt
3. Screws
4. Screwdriver
1
1. Templet guide
2. Convex portions
1
2
3
4
10mm(3/8")
1. Straight bit
2. Base
3. Templet
4. Distance (X)
5. Workpiece
6. Templet guide 10
10
Remove the tool base from the tool. Loosen the wing bolts
002006
and secure the tool base horizontally. Loosen the two screws
3
on the tool base.
4
Place the templet guide on the tool base. There are four con-
002007
vex portions on the templet guide. Secure two of the four
convex portions using the two screws. Install the tool base on
the tool.
2
Secure the templet to the workpiece. Place the tool on the
001988
templet and move the tool with the templet guide sliding
6
along the side of the templet.
NOTE:
• The workpiece will be cut a slightly different size from the
5
templet. Allow for the distance (X) between the router bit
and the outside of the templet guide. The distance (X)
can be calculated by using the following equation:
Distance (X) = (outside diameter of the templet guide –
router bit diameter) / 2
Straight guide (optional accessory)
001989
The straight guide is effectively used for straight cuts when
chamfering or grooving.