Starting The Empty Freezer; Freezing Fresh Foods; Proper Freezing Procedure - Beko UFC524W Instructions For Use Manual

Upright freezer
Table of Contents

Advertisement

Use

Starting the empty freezer

Switch the freezer on. Sound alarm is on because of inappropriate
temperature. It may be switched off by pressing the alarm button
Put the mode selection switch to the continuous operation position. All
three signal lamps are on. Place fresh food into the freezer several
hours after the red signal lamp goes off.

Freezing Fresh Foods

Proper use of the appliance, adequately packed food, correct
temperature and taking into account hygienic precautions will
substantially influence the quality of freezing the food or storing of the
frozen foodstuffs.
• Carefully select food to be frozen: it should be of adequate quality and
suitable for freezing.
• Choose correct packaging for each kind of food and pack it correctly.
− The packaging should be air tight and well sealed without leaking
since this could cause substantial vitamin loss and dehydration.
− Foils and bags should be soft enough to tightly wrap around the food.
• Mark packages with following data: kind and amount of foods and the
date of loading.
• It is most important that the food is frozen as quickly as possible. We
therefore recommend the size of the package not to be too large and to
be cooled before loading into the freezer.
• The amount of the fresh foods that can be loaded in the freezer within
24 hours is stated on the rating plate. If the loaded amount is too large,
the quality of freezing is reduced which affects the quality of frozen
foods.

Proper freezing procedure

Freeze the food in the freezing compartment (see Section Description
of the Appliance)
− 24 hours prior freezing of fresh food switch the continued operation
button (2) to the uninterrupted operation (yellow lamp is on). At the
end of this period load fresh food into the freezing compartment.
− After 24 hours move the frozen food to the storage compartment of
the freezer and repeat the freezing procedure with new load if
required. Fresh food should not touch the already frozen packages.
− Approximately 24 hours after the last loading of fresh food press the
continued operation button again (2) and switch to the automatic
operation (yellow signal lamp is off).
60
Instructions for Use
.

Advertisement

Table of Contents
loading

Table of Contents