Please read and comply with Environmental protection these original instructions prior to the initial operation of your appliance and store them for later use or subsequent own- The packaging material can be ers. recycled. Please do not throw Before first start-up it is definitely nec- –...
40 Water shortage safeguard Overview 41 Sieve in the water shortage safeguard 42 Fine filter (water) Device elements Operating field Figure 1 1 Support for spray lance Figure 2 2 Recess for detergent suction hose A Power switch 3 Recessed grip (both sides) 1 Indicator lamp for detergent 4 Wheel 2 “Ready for use”...
Caution Safety valve Always connect the system separator to The safety valve opens, when the over- – the water supply, never directly to the appli- flow valve resp. the pressure switch is ance! broken. Proper use The safety valve is set by the manufacturer and sealed.
Page 8
Install the hand-spray gun, the jet Water connection pipe, the nozzle and the high pres- For connection values refer to technical sure hose specifications Attach supply hose (minimum length Figure 5 7.5 m, minimum diameter 3/4“) to the Connect ray tube with hand spray gun water supply set by means of a hose ...
Caution Turning on the Appliance The highest allowed net impedance at the Set appliance switch to desired operat- electrical connection point (refer to techni- ing mode. cal data) is not to be exceeded. In case of Indicator lamp for operational readiness confusion regarding the power impedance lights up.
Page 10
Open the hand spray gun. Recommended cleaning method Turn on pump shortly (appr. 5 seconds) Loosen the dirt: – with device switch. Spray detergent economically and let it Pull main plug out of socket with dry work for 1...5 minutes but do not let it hands only.
Your Kärcher vender will inform you Flush device with anti-freeze agent about the performance of a periodic Note: Observe handling instructions of the safety inspection resp. signing of a anti-freeze agent manufacturer. maintenance contract. Use commercially available anti-freeze agent. Maintenance intervals ...
Note: If necessary turn in screw M8 appr. 5 Device is not building up pressure mm inwards and therewith pull out sieve. Low pressure nozzle is installed Clean sieve in water. – Replace the low-pressure nozzle with Push sieve inwards. the high-pressure nozzle (stainless ...
Accessories and Spare Parts Burner does not start Fuel tank empty. – Note: When connecting the appliance to a Refill fuel. chimney or if the device cannot be ac- Water shortage cessed visually, we recommend the instal- – lation of a flame monitor (option). ...
Technical specifications HDS 5/12 C Main Supply Voltage Current type 1~ 50 Connected load Protection (slow) Type of protection IPX5 Protective class Maximum allowed net impedance 0.4526 Water connection Max. feed temperature °C Min. feed volume l/h (l/min) 700 (11,7) Suck height from open container (20 °C)
Page 16
AU Kärcher Pty. Ltd., 40 Koornang Road, Scoresby VIC 3179, +371-67 80 87 07 Victoria, +61-3-9765-2300, www.karcher.com.au MX Karcher México, SA de CV, Av. Gustavo Baz No. 29-C, Col. Naucalpan Centro, Naucalpan, Edo. de México, BE Kärcher N.V., Industrieweg 12, 2320 Hoogstraten, C.P. 53000 México, +32-3-340 07 11, www.karcher.be...