Extended Function Parameter List - Mitsubishi Electric FR-S500 Instruction Manual

6.3 Extended function parameter list

Setting "1" in Pr. 30 "extended function display selection" makes the extended function
parameters valid. (Refer to the separately available instruction manual (detailed).)
Parameter
Indication
For parameters 0 to 9, refer to the basic function parameters.
DC injection brake
10
operation frequency
DC injection brake
11
operation time
DC injection brake
12
voltage
13
Starting frequency
14
Load pattern selection
15
Jog frequency
Jog acceleration/
16
deceleration time
RUN key rotation
17
direction selection
Base frequency
19
voltage
Name
Set the timing of switching to DC injection
brake (0 to 120Hz), the time to apply DC
injection brake (0 to 10s), and the braking
torque at DC injection brake start (0 to
15%). (Set Pr. 12 to 4% when a constant-
torque motor is used.)
Frequency which is output by the inverter
first at a start and gives great influence to
the starting torque. About 1 to 3Hz for
vertical lift applications, or up to 5Hz to the
maximum. For other than vertical lift
applications, factory setting of about 0.5Hz
is recommended.
0 to 60Hz
Choose the output frequency and output
voltage patterns according to the
application (load characteristic).
0: For constant-torque loads (when
relatively large torque is needed at low to
high speeds)
1: For variable-torque loads (for
applications where torque is small at low
speed, e.g. fans and pumps)
2: For vertical lifts
(for elevators at reverse rotation boost of
0%)
3: For vertical lifts
(for elevators at forward rotation boost of
0%)
Speed command (0 to 120Hz) and
acceleration/deceleration slope (0 to 999s)
for jog (inching) operation
When the FR-PU04 is connected, these
parameters can be read as the basic
parameters.
The
used to choose the direction of rotation for
operation.
0: Forward rotation, 1: Reverse rotation
Indicates the magnitude of the output
voltage at the base frequency (Pr.3)
888: 95% of power supply voltage
- - -: Same as power supply voltage
0 to 800V, 888, - - -
Extended function parameter list
Description
of the operation panel can be
RUN
31
Factory
Setting
3Hz
0.5s
6%
0.5Hz
0
5Hz
6
0.5s
0
- - -