Operation Display - Mitsubishi Electric FR-S500 Instruction Manual

Setting the parameters
4.3.2 Example: Changing the Pr. 30 setting from "0" to "1"
(The extended parameters are made valid by setting "1" in Pr. 30 "extended function
display selection". Refer to page 31 for the extended function parameter list and to the
instruction manual (detailed) for details.)
Operation
1.
Confirm the RUN indication and
operation mode indication.
The inverter must be
at a stop.
The inverter must be
in the PU operation mode.
2.
MODE
Press the to choose
the parameter setting mode.
3.
Turn the until
appears.
4.
SET
Press the to read
the currently set value.
"
" (factory setting) appears.
5.
Turn the to change it to
the set value of " ".
6.
Press the to set
SET
the value.
•
By turning the
•
Press the
•
Press the
After parameter setting is complete, press the
history or twice to return to the monitor display. To change the setting of
another parameter, perform the operation in above steps 3 to 6.
Error display?
REMARKS
If the setting has not been changed, the value does not flicker and the next parameter number
appears.
(Press the
(Pr. 30)
, you can read another parameter.
SET
to show the setting again.
SET
twice to show the next parameter.
• If the operation panel does not have the write precedence
• If write was performed during operation.
• If write was performed in the external operation mode
PU
.)
EXT
MODE
SET
SET
Flicker...Parameter setting complete!!
once to show the alarm
MODE
18
Display
RUN
PU
EXT
The parameter
number read
previously
appears.