Table of Contents
Advertisement
Installation Guide
7
The Access Point contains runtime firmware which enables the unit to boot after either a power up or a watchdog
reset. The runtime firmware on the Access Point can be updated via the Ethernet interface.
The front of the AP-6511E has an access cover that can be removed to expose an additional connector. A three port
RJ-45 Ethernet expansion module connects to the hidden header and snaps onto the AP-6511E in place of the
access cover.
Remove the AP-6511E's access cover by inserting a long pointed tool into the circular hole (opening) on the bottom
of the AP-6511E. Pull the access cover up and away from the AP-6511E. Reverse the procedure to install the
expansion module.
The Ethernet expansion module has three ports labeled FE2, FE3 and FE4.
The expansion module (KT-6511-0000D-WR) is a separately orderable component from Motorola Solutions.
Advertisement
Table of Contents
