Lan - TP-Link RE210 User Manual

4.3.1 LAN

Selecting Network > LAN will enable you to configure the IP parameters of Network on this page.
MAC Address - The physical address of the LAN port, as seen from the LAN. The value

cannot be changed.
Type - Several IP types are supported, including: (1) Dynamic IP; (2) Static IP, and they are

explained below.
Dynamic IP - In this type, if your range extender have connected to a router, your client

will dynamically get a IP Address / Gateway from the router, otherwise the client will get a
IP Address / Gateway in the same network as you set below. And this type is
recommended.
Static IP - In this type, you can configure IP Address / Gateway manually.

IP Address - Enter the IP address of your Range Extender in dotted-decimal notation (factory

default setting is 192.168.0.254).
Subnet Mask - An address code that determines the size of the network. Normally use

255.255.255.0 as the subnet mask.
Gateway - The gateway should be in the same subnet as your IP address.


Note:
1. The IP parameters cannot be configured if you have chosen Dynamic IP. In this situation the
device will automatically configure the IP parameters appropriate to your need.
RE210 AC750 WiFi Range Extender User Guide
Figure 4-3 LAN – Dynamic IP
Figure 4-4 LAN – Static IP
14