Working Techniques; General Working Instructions - Husqvarna 327P4 Operator's Manual

General working instructions

IMPORTANT!
This section takes up the basic safety precautions for
working with a pole saw.
If you encounter a situation where you are uncertain how
to proceed you should ask an expert. Contact your dealer
or your service workshop.
Avoid all usage which you consider to be beyond your
capability.
WARNING! The machine can cause
!
serious personal injury. Read the safety
instructions carefully. Learn how to use
the machine.
WARNING! Cutting tool. Do not touch the
!
tool without first switching off the
engine.
Personal protection
• Always wear boots and other equipment described
under the heading Personal protective equipment.
• Always wear working clothes and heavy-duty long
trousers.
• Never wear loose clothing or jewellery.
• Make sure your hair does not hang below shoulder
level.
Safety instructions regarding the
surroundings
• Never allow children to use the machine.
• Ensure that no-one comes closer than 15 m while you
are working.
• Never allow anyone else to use the machine without
first ensuring that they have read and understood the
contents of the operator's manual.
• Never work from a ladder, stool or any other raised
position that is not fully secured.
1156923-32 Rev. 1 2014-05-21

WORKING TECHNIQUES

Safety instructions while working
• Always ensure you have a safe and stable working
position.
• Always use both hands to hold the machine. Hold the
machine at the side of your body.
• Use your right hand to control the throttle setting.
• Make sure that your hands and feet do not come near
the cutting attachment when the engine is running.
• When the engine is switched off, keep your hands and
feet away from the cutting attachment until it has
stopped completely.
• Watch out for stumps of branches that can be thrown
out during cutting.
• Always lay the machine on the ground when you are
not using it.
• Check the working area for foreign objects such as
electricity cables, insects and animals, etc, or other
objects that could damage the cutting attachment,
such as metal items.
• If any foreign object is hit or if vibrations occur stop the
machine immediately. Disconnect the HT lead from
the spark plug. Check that the machine is not
damaged. Repair any damage.
• If anything gets caught up in the cutting equipment
while you are working, switch off the engine and let it
stop completely and remove the ignition lead before
cleaning the cutting equipment.
• This machine is not electrically insulated. If the
machine touches or comes close to high-voltage
power lines it could lead to death or serious bodily
injury.
Safety instructions after completing work
• The transport guard should always be fitted to the
cutting attachment when the machine is not in use.
• Make sure the cutting attachment has stopped before
cleaning, carrying out repairs or an inspection.
Disconnect the HT lead from the spark plug.
–
English 53