Adjust Handset Rest - Cisco 8941 User Manual

Adjust Handset Rest

Procedure
Step 1 Insert the curved connectors into the lower slots.
Step 2
Lift the footstand until the connectors snap into the upper slots.
Note
Adjust Handset Rest
If your phone is wall-mounted, you may need to adjust the handset rest to ensure that the receiver does not
slip out of the cradle.
Procedure
Step 1 Remove the handset from the cradle and pull the plastic tab from the handset rest.
Step 2
Rotate the tab 180 degrees.
Step 3 Hold the tab between two fingers, with the corner notches facing you.
Step 4 Line up the tab with the slot in the cradle and press the tab evenly into the slot. An extension protrudes from
the top of the rotated tab.
Step 5
Return the handset to the handset rest.
Cisco Unified IP Phone 8941 and 8945 User Guide for Cisco Unified Communications Manager 10.0 (SCCP and
SIP)
12
Connecting and disconnecting the footstand may require a little more force than you expect.
Phone Setup