Cisco PA501G Quick Start Manual page 4

STEP 1
Turn the phone body over to expose the ports on
the back of the unit.
Caution
Do not insert a telephone line cord into
the auxiliary port.
STEP 2
Insert the long end of the phone cord into the
handset port on the phone body that is marked
with a phone symbol.
STEP 3
(Optional) Route the phone cord through the
cable slot.
STEP 4
Insert the other end of the phone cord into the
port at the bottom of the handset (not shown).
STEP 5
(Optional) Connect the phone stand by lining up
the tabs on the stand with the slots on the phone
body. Slide the bottom tabs into the lower slots
on the phone body and lightly press down on the
stand. It should easily slide into the upper stand
slots. Do not force.
Cisco SPA 50X Quick Start guide
Connecting your business to the things that matter
www.kcbusiness.co.uk
STEP 6
If you are using an external power source, insert
one end of the power cord into an outlet and
insert the other end of the power cord into the
power port on the phone body.
STEP 7
Connect your phone to the network:
• Using an Ethernet Connection—Insert
one end of the Ethernet cable into the
network port on the phone body marked
"SW." Insert the other end of the Ethernet
cable into the appropriate device, such as a
network switch, on your network.
• Using a Wireless Connection—You can use
a Cisco WBP54G Wireless-G Bridge with the
IP phone to create a wireless connection
between the phone and the network. See
the WBP54G documentation on Cisco.com
for more information (see the list of links at
the end of this document).
Business
4