JTS US-902D Pro Instruction Manual page 19

US-903DC Pro
Selecting group channel:
1
Group set up:
Step 1
Press "SET" bu on two sec. till the "SETUP" show up, then "A-1" starts
ashing, press the Up or Down bu on to select a suitable group from
the pre-set four group of A,B,C,D.
Channel set up:
Step 2
en the channel number is ashing, press the Up or Down bu on to
select a suitable channel from the pre-set 16 channels.
A er step
store the se ing automatically.
Se ing Lock-On:
2
1. Press "SET" bu on two sec. repeat pressing till "Loc OFF" appeares. Press "UP"
bu on to lock-on mode and "DOWN" bu on to lock-o mode. Re-press "SET"
bu on the lock function will store.
2. To release the Lock-On mode. Press "SET" bu on two sec. till "LocON" show
up, then press "DOWN" bu on till "LocOFF" appears, press "SET" again then
lock-on relieved.
Se ing procedure is the same between channel A & B.
3
Channel A & B can't be set up in the same group and frequency, the system will
4
evade this problem automatically.
e lock-on or lock-o is e ective either A or B simultaneously.
5
Step 1 & Step 2 , again press "SET" bu on the receiver will
en, press "SET" to store the group.
16