1. Manuals
  2. Brands
  3. Kärcher Manuals
  4. Floor Machine
  5. KM 130/300 R LPG
  6. User manual

Kärcher KM 130/300 R LPG User Manual

Hide thumbs Also See for KM 130/300 R LPG:
Table of Contents

Advertisement

Quick Links

Download this manual
KM 130/300 R LPG
59641380 08/13

Advertisement

Table of Contents
loading

Related Manuals for Kärcher KM 130/300 R LPG

Summary of Contents for Kärcher KM 130/300 R LPG

  • Page 1 KM 130/300 R LPG 59641380 08/13...

  • Page 3: Table Of Contents

    Please read and comply with Drive mode Machines with driver cabin these original instructions prior In emergencies, destroy the windows – Danger to the initial operation of your appliance and with a hammer. Risk of injury, risk of damage! store them for later use or subsequent own- Note Danger ers.
  • Page 4 First close the cylinder valve before Close all cylinder and main valves be- – – Maintenance by expert loosening the pipe or tube connection. fore working in repair workshops and Propellant-operated units are to be – Unscrew and loosen the connection nut protect the gas cylinders against effect checked at regular intervals, at least of the gas cylinder slowly because oth-...

  • Page 5: Function

    The machine may not be used or stored – Symbols on the machine Symbols in the operating in hazardous areas. It is not allowed to instructions use the appliance in hazardous loca- Risk of burns on account tions. Danger of hot surfaces! Allow the The following applies in general: Keep –...

  • Page 6: Operating And Functional Elements

    Operating and Functional Elements Illustration of sweeper Operating field Ignition lock 1 Driver cabin (optional) 2 Cabin door (option) 3 Tank lid 4 Lashing point (4x) 5 Roller brush access 6 Front wheel 7 Side brushes 8 Lighting system (optional) 1 Warning blinking switch (option) 9 Waste container 2 Ignition key...

  • Page 7: Before Startup

    Multifunction display Before Startup Start up Fold up the cab General notes  Read the operating instructions of the In order to perform different tasks, you may have to fold up the cab (optional) first. engine manufacturer before start-up Note: The cab must only be tilted while the and follow the safety instructions care- vehicle is on even ground (±...

  • Page 8: Operation

    Installing a new gas bottle Adjust engine speed Drive the machine  Replace the gas cylinder.  Set programme selection switch to Observe the installation position of the "Transport drive". gas cylinder. The connection / ring  Move the gas lever all the way to the opening must point downwards.

  • Page 9: Transport

    Sweeping dry floors Shutdown  Switch on the blower. If the sweeper is going to be out of service for a longer time period, observe the follow- ing points:  Park the sweeper on an even surface.  Raise the roller brush and the side- ...
  • Page 10 Safety notes regarding the batteries Maintenance intervals Maintenance Works Please observe the following warning notes Observe the inspection checklist 5.950- Preparation: when handling batteries:  Park the sweeper on an even surface. 647.0! Observe the directions on the  Turn ignition key to "0" and remove it. Note: The elapsed-time counter shows the battery, in the instructions for timing of the maintenance intervals.
  • Page 11 Installing and connecting the battery Remove the battery Change the motor oil and the oil filter  Insert battery in battery mount.  Disconnect pole terminal to negative Caution  Screw on mounts on battery base. pole (-). Risk of burns due to hot oil! ...
  • Page 12  Install new roller brush. The nuts of the Check hydraulic oil level and refill hy- Checking roller brush roller brush must be inserted on the  Start the motor. draulic oil notches of the opposite crank.  Raise the waste container up to the Note Note: Once the new roller brush has been end-position.
  • Page 13 Check the tyre pressure  Park the sweeper on an even surface.  Connect air pressure testing device to tyre valve.  Check air pressure and adjust if re- quired.  For permissible tyre air pressures see "Technical data". Manually clean the dust filter ...

  • Page 14: Ec Declaration Of Conformity En

    Changing the headlight bulb (option) EC Declaration of Conformity  Unscrew the head lamps. We hereby declare that the machine de-  Take out the head lamps and pull out scribed below complies with the relevant the plug. basic safety and health requirements of the Note: Note the positions of the plugs.

  • Page 15: Troubleshooting

    Troubleshooting Fault Remedy Appliance cannot be started Sit on the driver seat, the seat contact switch gets activated. Charging or replacing battery Gas bottle empty - replace gas bottle. Gas removal valve closed - open the valve by turning it in anti-clockwise direction. Gas valve iced - please read the description of the gas bottle replacement procedure.

  • Page 16: Technical Specifications

    Technical specifications KM 130/300 R LPG Machine data Drive speed, forward km/h Drive speed, reverse km/h Climbing capability (max.) Surface cleaning performance without side brushes 10000 Surface cleaning performance with 1 side brushes 13000 Working width without side brushes 1000...
  • Page 17 Brake Front wheels mechanical Rear wheel hydrostatic Filter and vacuum system Type Flat fold filter Speed 1/min 2800 Filter surface area, fine dust filter Nominal vacuum, suction system mbar 15,5 Nominal volume flow, suction system Vibrator system Electric motor Working conditions Temperature °C -5 and +40...
  • Page 19 http://www.kaercher.com/dealersearch...

Table of Contents