Advertisement
Metal cutting
Always use a suitable coolant (cutting oil) when cutting metal. Failure to do so will cause
significant
blade
wear.
The
underside
of
the workpiece
can
be greased instead
of
using
a
coolant.
Anti-splintering device
To reduce the potential for workpiece sur-
face splintering, the anti-splintering device
can be used. Fit it into the base from below
so that
it
surrounds the sides
of
the blade.
Plastic base plate (optional accessory)
Use the plastic base plate when cutting
decorative veneers, plastics, etc. It protects
sensitive or delicate surfaces from damage.
To replace the base plate, remove the four
screws with the hex wrench.
Guide rule (rip fence; optional accessory)
When cutting widths of under 150 mm
(5-29/32") repeatedly, use of the guide rule
will assure fast, clean, straight cuts. To
install it, loosen the bolt on the front of the
base.
Slip in
the guide rule and secure the
bolt.
Anti-sprintering device
L
13
Advertisement
